An analysis of aluminum

An evaluation was performed on the preparation of stock dye solution. This study serves as foundation for water research for undergraduate students and monitoring water quality on the Columbia College campus. In visible light spectrometry, the absorbance of a set of standard solutions with various concentrations of the element of interest is obtained using the visible spectrometer. In the case of the blank, sample preparation using glassware that was not acid washed could have introduced aluminum contamination. The following tables present data for the initial intensity of chloroform, standard, blank, and samples. The samples were allowed to stand for 10 minutes before analysis in Trial 1. However, chloroform still did not show any emission peak at Ashley Daugherty and Nephron Pharmaceuticals Corporation for the internship position that inspired me to conduct research in water analysis. Ackowledgements First and foremost, I would like to thank Dr. The amount of acid used was recorded. Then, 10 mL of this solution was diluted to mL with deionized water. Journal American Water Works Association. Adrienne Oxley for their guidance on conducting research and data analysis. Table 1. The data was consistent among the three trials see Figures 1, 2, and 3.

Additionally, the deionized water was not tested for a fluorometer signal. Water Quality Report.

how to test for aluminum in drinking water

The recovery of the standard was relatively efficient, demonstrating the precision of the measurements and the insignificance of the chloroform evaporating.

Then, two new 25 mL portions of sample were added to 50 mL volumetric flasks. These results are used to determine if samples pass or fail the SMCL of 0. Baseline correction is applied by subtracting the intensity of chloroform and then the blank from the initial intensity of all samples, illustrating the final representative aluminum concentrations of samples.

Epub May Second, I would like to thank Columbia College and the Division of Business, Mathematics and Sciences for all materials and supporting science students in undergraduate research.

The aluminum standard of 2 ppm was prepared from a larger ppm aluminum standard, which was obtained by dissolving 0. Electronic address: jomana. Samples from McNair and Dining Hall, displayed in red, fail the aluminum test with concentrations higher than 0. The standard solution was a mixture of 2 mL of the aluminum standard solution, which contained 2 ppm of aluminum, 10 mL of acetate buffer solution, pH 6. All the results obtained from Trial 1 were lower than those from Trial 2 see Tables 2 and 3. This problem was encountered in the sample preparation. Then, 10 mL of this solution was diluted to mL with deionized water. Under a constant exposure to aluminum, animals and humans undergo the risk of developing a range of symptoms, including nausea, skin ulcers, vomiting, and diarrhea. The grid was then flipped end-over-end with sediments collected at the next interval. Other researchers have shown that some soils high in reactive amphorous iron and aluminum compounds absorb large amounts of arsenic, Jacobs et al. The results from the fluorometry method indicated that samples from two locations on campus were higher than the SCML limit for aluminum of 0. During seasonal migrations, Gray whales frequent the coastal areas of Washington and often feed in Puget Sound. In this experiment, tap water samples were obtained and tested for aluminum concentration by first fluorometry and then visible spectrometry. Stock dye solution was obtained by adding mg of eriochrome cyanine R Sigma-Aldrich to 50 mL of deionized water. Water Quality Report.

According to the method referenced8, all standards were allowed to stand for 10 minutes after being diluted to the correct volume.

In nature it exists as a trivalent metal. One mL of the ppm solution was then diluted to mL to obtain the 2 ppm aluminum standard.

standard test method for aluminum in water

All Nalgene bottles were rinsed with deionized water three times before sample collection. Bartram, J.

A few drops of methyl orange were added to 25 milliliters of sample which was then titrated with 0. Electronic address: m.

Rated 8/10 based on 7 review
Download
Aluminum Analysis of Water